Your browser is outdated. Upgrade to a modern browser to better experience this site.

Machine Feet Guide

MACHINE FEET GUIDE

The first question to answer is how old is your machine? Most machines made since 1980 use snap-on feet (Except Berninas, which have their own style of attaching, and therefore need an adaptor).

Does your machine's foot screw on or snap on? If it doesn't use a screw to attach, then it's a snap-on.

If it screws on it is important to know whether your machine is a low shank, high shank, or slant needle machine. If you are not certain, you can measure using the simple instructions below:

To Measure:
When presser foot is down, measure the distance from the bottom of foot to screw-hole that holds the foot onto the presser bar.

Machine Feet Guide
  • Singer slant is for slant needle machine only.
  • A high shank machine measures approximately 1 1/4" from the screw to the bottom of the foot.
  • A low shank machine measures approximately 3/4" from the screw (small dot in picture above) to the bottom of the foot.
TIPS
  1. Most machines made since 1980 use snap-on feet. (Except Berninas that have their own style of attaching, and therefore need an adaptor).
  2. If foot is not screwed on, it is a snap-on.
  3. All Viking machines are snap-on. Viking (Huskvarna) and Pfaff are European made.
  4. Most Japanese machines are snap-on (Brother).
  5. All Berninas need "Shank Adaptor" and use generic low shank feet.
  6. Singer Slant IS FOR SINGER SLANT MACHINES only. (All other Singers have snap-on or screw on feet.)
  7. All Featherweights use low shank feet. They are center needle position machines.
  8. For super high-bar lever-style Kenmore, use a High-bar adaptor.
  9. Sergers are called Overlock Machines everywhere except USA.
Learn Sewing
Share This Lesson question mark bubble